Speaker Setting - Kenwood DVR-605 Instruction Manual

Speaker setting

54
Positioning the speakers
To achieve the optimum effects obtainable with this SURROUND SOUND system, it is important to position the speakers
properly. Refer to the following illustration to find the best location in your room.
Preparation
1 Play a disc marked "Dolby Digital".
2 Stop the playback.
For this unit, the speaker levels have been set in advance so that the best volume balance is obtained with
standard use.
Initial set values for the speaker level
Left Front channel (Lch)(L)
Center channel (Cch)(C)
Right Front channel (Rch)(R)
Right Surround channel (RSch)(RS) : 0dB
Left Surround channel (LSch)(LS)
Subwoofer(SW)
Reset as follows to match your listening environment.
Speaker level setting
1 Press SETUP key for more than 2
seconds
2 Press the TRIM (5/∞) keys to con-
trol the speaker level.
÷ After all speakers have been adjusted, operate the
Delay time setting (T).
÷ If you want to quit at this time, press the ENTER
key.
§
3
AUTO/MONO
7
: 0dB
: 0dB
: 0dB
: 0dB
: 0dB
SETUP
Active EQ./
SOUND
5
TRIM
∞
Center speaker
C
L
SW
LS
Front speaker
Sub woofer
Front speaker
Surround
speaker
The test tone is played back from the Left Front speaker.
Adjust the VOLUME CONTROL so that it is slightly loud
and fix it there.
The speakers will be switched as follows in intervals of
about 2 seconds.
L C R RS
Adjust the volume with the TRIM (5/∞) keys while the
indicator is flashing so that the volume from all speakers
except the subwoofer (SW) appears the same. Level ad-
justment is possible in the range from -10 dB to +10 dB.
Note
Note
As the subwoofer (SW) has a special playback band, nor-
mal adjustment is not possible with the test tone. Please
adjust the subwoofer while listening to actual music. (Y)
DVR-605/DVR-6100/DVR-6100K (EN)
R
RS
Surround
speaker
"L" Blinks.
LS SW