Configure Sfp+ Ports For Lag (M8024); Save Configuration; Configure Additional Switch - Dell PowerConnect 8024 Configuration Manual

console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
3.14

Configure SFP+ ports for LAG (M8024)

Note: The commands in this section assign four 10Gb SFP+ ports from an optional expansion module in
the first expansion slot, to the Port Channel. If you have the M8024-k switch, see section 3.13 instead.
console(conf)#interface range tengigabitethernet 1/1/1-4
console(conf-if)#channel-group 1 mode active
console(conf-if)#exit
console(conf)#exit
3.15

Save configuration

console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
3.16

Configure additional switch

Repeat the commands from section 3 to configure the second switch.
Note: The preceding procedure places all switch ports in the default VLAN. If you prefer to place ports in a
non-default VLAN, refer to the documentation for your switch.
14 SCG1008 PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs