Save Configuration (Switch 2); Final Configuration; Disable Dcb - Dell PowerConnect 8024 Configuration Manual

Note: the switch will reboot.
console>enable
console#configure
console(config)#stack
console(config-stack)#stack-port tengigabitethernet 2/0/21 stack
console(config-stack)#stack-port tengigabitethernet 2/0/22 stack
console(config-stack)#stack-port tengigabitethernet 2/0/23 stack
console(config-stack)#stack-port tengigabitethernet 2/0/24 stack
console(config-stack)#exit
console(config)#exit
4.7

Save configuration (switch 2)

console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
4.8

Final configuration

Power off switch 2, and then connect the cables between the stacked switches (ports 21-24).
Power on switch 2 and wait until it has fully booted.
From the first switch (master) complete the configuration for the stack:
console>enable
console#show switch
Note: Before proceeding ensure that the status for all switches in the stack show OK.
4.9

Disable DCB

Note: The PowerConnect 8024 and 8024F switches do not support Enhanced Transmission Selection
(ETS), therefore Data Center Bridging (DCB) must be manually disabled using the following steps:
console#configure
console(config)#no dcb enable
17 SCG1008 PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs