Table of Contents
Advertisement
ADVANCED CONFIGURATION
EN
Camera Management: Video Loss
Video Loss is regarded as a potential alarm event, and is
considered to occur any time that the DVR doesn't receive
an active video signal on any of its inputs.
The default behaviour of the DVR, when a channel has
no incoming video signal, is simply to display "No Video"
in white text on a black background over the associated
channel. If you're not using all the inputs on your DVR, then
some channels will be in "permanent" video loss state. Just
be sure that you don't enable a video loss action for these
channels.
Camera: Which channel/camera you'd like to set the video
loss behaviour for.
Enable Video Loss Alarm: Whether the selected channel
has video loss monitoring active or not.
Camera Management: Video Loss - Handling
Full Screen Monitoring: When the video signal has re-
established connection, the camera will display a full screen
image momentarily.
Audible Warning: The DVR will use its internal buzzer
to emit an alarm tone. It sounds like an old computer
indicating an error, or a large truck backing up.
Alert CMS Software: A warning message is sent to the
SwannView Plus client software installed on the computer.
Send Email: The DVR will send an auto-email alert when
the event type you've selected occurs. To configure your
email settings - see "Configuration: Network: Email" on page
22 for details.
Trigger Alarm Output: Instructs the DVR to output an
alarm signal from the alarm output terminal(s). The alarm
output(s)must be correctly connected and configured.
51
51
Advertisement
Table of Contents
