Disassembly For Repair - Kenwood TK-260G Service Manual

TK-260G/270G
Separating the case assembly from the chassis.
1. Remove the two knobs
2. Remove the two screws
3. Expand the right and left sides of the bottom of the case
assembly, lift the chassis, and remove it from the case
v
assembly .
4. Taking cure not to cut the speaker lead
and case assembly, and pull the speaker lead with
n
connector .
16

DISASSEMBLY FOR REPAIR

z x
and three round units .
c
.
stopper
b
, open the chassis
b
CN3
n
Separating the chassis from the unit.
• TK-260G
1. Remove the twelve small screws
,
screws .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
• TK-270G
1. Remove the three screws
Lift the unit (X54), and rise up the connecter lever in the
/
arrow with your finger .
Remove the three hexagonal bosses
m
twelve screws .
2. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off (X57).
TK-270G
X54-
Ω
Ω
Ω
X57-
m
, and the three large
.
.
-
, and remove the
1 1
Antenna teminal
X57-