Table of Contents
Advertisement
3. FERRITE CORE INSTALLATION
NOTE: Take special care when following the procedures listed below.
Two ferrite core noise filters, large and small, come packed with the printer.
The small noise filter is for the RS232C serial interface cable, while the larger
one is for the cable of peripheral units.
Ø24mm
The ferrite cores are packed so they
are open, as shown in Fig. 3-2. If you
find that a ferrite core is not open, use
a pointed object to pry the plastic lock
of the ferrite core apart (Fig. 3-1).
When you do, take care not to damage
the ferrite core or the plastic lock.
Small ferrite Core(24mm diameter)
Interface
Cable
Fig. 3-2
Product
09990728
Code
Model
Ferrite Core
Name
TFC-20-10-10
For Interface Cable
Pass fastener through ferrite core.
Pass fastener around cable and lock it.
Cut off excess with scissors.
– 3 –
*EUROPE ONLY
Ø28mm
For Peripheral Unit Cable
Fig. 3-1
5cm
maximum
Fig. 3-3
Fig. 3-4
Product
09990723
Code
Model
Ferrite Core
Name
TFC-23-11-14
Fastener
Pull and cut
Advertisement
Chapters
Table of Contents
