Connecting Wires To Terminals - Kenwood KDC-MP435U Instruction Manual

Connecting Wires to Terminals

Fuse (10A)
To Kenwood disc changer/
External optional accessory
Wiring harness
(Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
30
|
English
FM/AM antenna input
Front left output (White)
Front right output (Red)
Rear left output (White)
Rear right output (Red)
To connect these leads, refer to the relevant instruction
manuals.
White
White/Black
To front left speaker
Gray
Gray/Black To front right speaker
Green
Green/Black
To rear left speaker
Purple
Purple/Black
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power
control terminal.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal
for the booster amplifier of the film-type antenna.
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
To connect the Kenwood navigation system, consult your
navigation manual.
To car light control switch
Car fuse
box
ACC
Sub Woofer left output (White)
Sub Woofer right output (Red)
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
Ignition key
switch
Car fuse box
(Main fuse)
Battery