Section C: Using Stealth-M1 Accessories; Chapter 6: Using Customer Display/Rear Display (Optional, Part Number "46B-Rbrj") - PIONEERPOS Stealth-M1 User Manual

Section C: Using Stealth-M1
accessories
Chapter 6: Using Customer Display/Rear Display (optional, part
number "46B-RBRJ")
Unless specified, standard Rear Display/Customer Display shipped from PioneerPOS is set to AEDEX protocol by default.
6.1 Protocol/emulation supported
Pioneer POS rear display/customer display supports a few different protocols. The supported protocols are:

General

AEDEX

UTC standard

UTC Enhanced

Epson

CD7220 (CD5220-II)

PD3000
6.2 Reprogram rear display protocol/emulation
Please obtain the utility to reprogram Rear Display Protocol by contacting PioneerPOS Technical Support.
If you need to re-program the rear display firmware, you may connect the display to COM1/COM2/COM3/COM4 or COM5.
After that, run the "PPOSx.EXE" (x stands for version number, for example: "PPOS4.exe") utility. Please follow the steps
below when after PPOS program is loaded:
1. Enter the Com port that is connected to your rear display (You can choose COM1, COM2, COM3, COM4, or
COM5).
2. Please input Command code number for the protocol that you wish to change to at the text filed after the line
"Please Input Command Code Number".
Manual for Stealth M1 v1.0 Page 17