Table of Contents
Advertisement
Section B: Using Stealth-M1
system
Chapter 3: Touch screen panel
Stealth-M1 Touch Screen can be operated with finger or soft stylus. The touchscreen for each of the terminal shipped
from factory is pre-calibrated. If you have re-installed the driver software, you may need to open TouchKit utility to re-
calibrate the touch screen:
1.
Go to Start -> All Programs -> eGalaxTouch -> Configure Utility.
Click on "Tools" when you need to calibrate.
2.
3.
Perform 4 point calibration when you see the calibration screen. Use a touch screen stylus pen or your finger to
touch each point for about 1-2 seconds until you hear a "beep" sound.
[Note] Linearization is not needed for regular use.
Picture: 4 point calibration screen
Manual for Stealth M1 v1.0
Page 12
Advertisement
Table of Contents
