Connecting Wires To Terminals - Kenwood KDC-X7533U Instruction Manual

Connecting Wires to Terminals

USB connector
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the Kenwood navigation
system, consult your navigation manual.
To car light control switch
To "EXT.AMP.CONT. " terminal of the amplifier
having the external amp control function.
To front right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+
36
|
English
To USB device
Front left output (White)
Front right output (Red)
Rear left output (White)
Rear right output (Red)
To Kenwood disc changer/ External optional accessory
To front left speaker
To rear left speaker
To rear right speaker
Car fuse box
–
• Do not remove the cap when you do not use the USB
cable. The connector will cause the unit to malfunction if
it gets in touch with any metallic part of the vehicle.
FM/AM antenna input
To connect these leads, refer to
the relevant instruction manuals.
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
Dimmer control wire (Orange / White)
ILLUMI
External amplifier control wire (Pink/Black)
EXT.
CONT
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
ACC
Ground wire (Black) - (To car chassis)
Sub Woofer right output (Red)
Sub Woofer left output (White)
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)