Table of Contents
Advertisement
3. Remove the headphone jack.
4. Insert a new headphone jack.
5. Insert the two screws, removed earlier, and tighten.
6. Insert two wire ties through the holes in the mounting bracket on
the back of the receiver.
7. Place the receiver on the neoprene mounting pad or rubber
adapter mounts, and then attach it to the equipment with the wire
ties. Use the pliers to tighten the wire ties so the receiver cannot
move.
Important: Be sure to secure the receiver on the handlebar so
that it cannot move. If the receiver moves, it may damage the
exercise equipment as well as itself, and void the Limited
Warranty.
8. Cut off the excess plastic from the wire ties, being careful not to
leave any sharp edges on the wire ties.
Installation and Maintenance Guide: Maintenance and Troubleshooting
Replacing the Headphone Cover on an
Integrated Receiver
When someone experiences no audio or poor audio quality (such as
intermittent audio or crackling), you should check the headphone
jack. The headphone jack is designed to be easily and quickly
replaced at the facility. Make sure you have a new headphone jack
(CX30315) before you begin.
1. Firmly grasp the headphone jack, located under the display
console. With one hand squeeze the sides near the top while
pulling down with your thumb using your other hand. See
Figure 21. You may find it helpful to wiggle the jack from side to
side. The headphone jack should pop off the display console,
with the audio cable still connected.
The headphone jack has two tabs on each side and one tab in
the back. These tabs help to secure the headphone jack to the
console.
Figure 21: Grasp the headphone jack and remove it from the
console
2. Disconnect the audio cable. You can discard the used
headphone jack.
21
Hide quick links:
Advertisement
Table of Contents
