Installing The Integrated Receiver On A Treadmill - Cardio Theater xTV900 Installation And Maintenance Manual

9. Feed the audio cable through the base of the display console
and attach it to the headphone jack. See Figure 8.
Figure 8: Attach audio cable to headphone jack
10. Insert the headphone jack into the base of the display console.
Snap the headphone jack into place by positioning the rear tab
first, and then applying pressure to the base. See Figure 9.
Figure 9: Snap headphone jack into place
11. Use a Phillips-head screwdriver to replace the back console
plate with the four screws removed in step 1. If you also removed
the neck cover (climber installation only), reinstall the neck cover
with the one screw.
Installation and Maintenance Guide: Install Integrated Receivers on Display Consoles
Installing the Integrated Receiver
on a Treadmill
1. Turn OFF the Precor treadmill and unplug it. The ON/OFF
(I/O) switch is located on the front of the treadmill beneath the
hood overhang.
2. Unplug any RJ45 connections from the back of the display
console cover before removing the cover.
3. Use a Phillips-head screwdriver to remove the nine screws that
secure the display console back cover. See Figure 10. Set the
fasteners aside.
Figure 10: Remove display console back cover screws
12