Table of Contents
Advertisement
4. Remove the headphone jack.
5. Insert a new headphone jack. Insert the two screws and tighten.
6. If needed to re-attach the receiver, insert two wire ties through
the holes in the mounting bracket on the back of the receiver.
7. If needed, place the receiver on the neoprene mounting pad, and
then attach it to the equipment with the wire ties. Use the pliers
to tighten the wire ties so the receiver cannot move.
Important: Be sure to secure the receiver on the handlebar so
that it cannot move. If the receiver moves, it may damage the
exercise equipment as well as itself, and void the Limited
Warranty.
8. If you re-attached the receiver, cut off the excess plastic from the
wire ties, being careful not to leave any sharp edges on the wire
ties.
9. Check the rubber boot over the RJ45 connector to make sure it
covers the connector with a tight seal.
Installation and Maintenance Guide: Maintenance and Troubleshooting
Replacing the Headphone Cover on an
Integrated Receiver
When someone experiences no audio or poor audio quality (such as
intermittent audio or crackling), you should check the headphone
jack. The headphone jack is designed to be easily and quickly
replaced at the facility. Make sure you have a new headphone jack
(CX30315) before you begin.
1. Firmly grasp the headphone jack, located under the display
console. With one hand squeeze the sides near the top while
pulling down with your thumb using your other hand. See
Figure 2. You may find it helpful to wiggle the jack from side to
side. The headphone jack should pop off the display console,
with the audio cable still connected.
The headphone jack has two tabs on each side and one tab in
the back. These tabs help to secure the headphone jack to the
console.
Figure 21: Grasp the headphone jack and remove it from the
console
2. Disconnect the audio cable. You can discard the used
headphone jack.
20
Advertisement
Table of Contents
