Install Integrated Receivers On Display Consoles; Unpacking The Equipment; Required Tools; Installing The Integrated Receiver On An Efx, Climber, Or Cycle - Cardio Theater xTV900 Installation And Maintenance Manual

Install Integrated Receivers on Display Consoles

This section explains how to install the xTV-9RAB integrated receiver
on a Precor cardio equipment console. You can also follow these
instructions to replace an existing integrated receiver. The
instructions differ depending on the type of equipment on which you
are installing. Choose the appropriate instructions based on your
situation.
Remember to read and follow the instructions in this guide. If you do
not install the xTV-9RAB receivers according to these instructions,
you could void the Limited Warranty.
Important: Wear a static guard on your wrist to safeguard against
static electricity damage to the electronic equipment housed in the
Cardio Theater and Precor units.

Unpacking the Equipment

The integrated receiver is shipped with the following items:
• One or more xTV-9RAB receivers as ordered
• Headphone jack cover, 1 per receiver
• These instructions
If any items are missing, contact the dealer from which you
purchased the unit or contact Cardio Theater Technical Support.
Installation and Maintenance Guide: Install Integrated Receivers on Display Consoles

Required Tools

Obtain these tools before assembly:
• Phillips-head screwdriver
• (Treadmill installation only) Flathead screwdriver
Installing the Integrated Receiver on an
EFX, Climber, or Cycle
1. Use a Phillips-head screwdriver to remove the four screws that
secure the back console plate. Set the screws and back console
plate aside.
If you are installing the integrated receiver on a climber, you will
also need to remove the one screw that secures the neck cover.
Set the neck cover and screw aside.
Climber
Figure 5: Remove back console plate
EFX or Cycle
10