Installing The Standalone Receiver - Cardio Theater xTV900 Installation And Maintenance Manual

Installing the Standalone Receiver

1. Identify the equipment on which you plan to attach the receivers.
You can attach receivers to almost any exercise equipment.
2. Determine where on the equipment you will install each receiver.
When you choose a location for the receiver, make sure that the
person can comfortably reach it and that its controls are easily
readable. Also, make sure that the receiver does not interfere
with the equipment's display console or moving parts.
You can attach a receiver either horizontally or vertically. You
cannot attach a receiver to handlebars that move.
3. If needed, loosen the screw in the mounting bracket and rotate
the bracket so the receiver can be comfortably used based on
where you will install it. Retighten the screw.
4. Connect the power cable into the RJ45 connector on the back of
the receiver. Push the rubber boot firmly into the recess around
the connector to ensure a tight seal. See Figure 2.
Important: Make sure that the rubber boot securely covers the
connector to prevent moisture damage, or you could void the
Limited Warranty.
Installation and Maintenance Guide: Install Standalone Receivers on Exercise Equipment
Mounting bracket
Rubber boot
Clamp
Figure 2: Back of receiver showing rubber boot being
properly installed
5. Secure the power cable to the receiver using the clamp attached
to the cable. Remove the two screws on the receiver, position
the clamp over the connector, and insert and tighten the two
screws.
8