Programming Each Receiver; Automatic Programming - Cardio Theater xTV900 Installation And Maintenance Manual

Programming Each Receiver

This section explains how to use the automatic programming
process to set up xTV900 receivers. During automatic programming,
the receiver acquires the available channels from the installed
transmitters, and assigns them to channel numbers. You will need to
follow this process for each new receiver, or when a receiver is
replaced.
After automatic programming, a receiver may be missing some
channels or the programming is incorrect. You will find a section that
explains how to manually program a receiver to add or remove
channels as needed.
You can follow the instructions in this section for both the standalone
and integrated receivers.
Installation and Maintenance Guide: Programming Each Receiver

Automatic Programming

1. Make sure all transmitters are properly installed and plugged in.
Important: Transmitters must not share the same channel,
because it will cause a problem for the automatic programming
feature of the receivers and affect the performance of the
wireless system.
2. Power up the receiver. If it is connected to self-powered exercise
equipment, you or an assistant will need to use the equipment.
The optional power adapter is a useful tool for self-powered
equipment.
3. Begin the automatic programming process on a receiver by
pressing the Channel ▲ and Mute buttons simultaneously for
3 seconds.
4. When the display shows "AP", release the buttons. The display
then shows a number from "-1" to "-5, " which indicates its
program mode.
Table 1: Receiver programming modes
Display Number Program Mode Description
-1 Cardio Theater xTV program mode (default)
-2 Cardio Theater LCS program mode
-4 Cardio Theater xTV program mode (Australia)
-5 Cardio Theater LCS program mode (Australia)
16