Connecting Wires to Terminals
To USB device
USB connector (1m)
Steering remote control (Light Blue/Yellow)
REMO.CONT
To use the steering wheel
remote control feature, you
need to an exclusive remote
adapter (not supplied) matches
your car is required.
Fuse (10A)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/ Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
8
6
4
2
7
5
3
1
8
6
4
2
Connector B
7
5
3
1
⁄
Do not remove the cap when you do not use the USB cable. The connector
will cause the unit to malfunction if it gets in touch with any metallic part of
the vehicle.
FM/AM antenna input (JASO)
AUX
AUX input (Stereo)
Use the mini-plug which is stereo type and does not have any resistance.
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction manuals.
MUTE
P.CONT
ANT.CONT
See next page.
KDC-W6541U/ KDC-W6641U
Front output
L
R
Rear output/ Sub Woofer output
KDC-W6041U/ KDC-W6141U
L
R
Rear output/ Sub Woofer output
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
English
27
|