Removing The Unit - Kenwood KDC-W6027 Instruction Manual

Removing the Unit

Removing the hard rubber frame
1
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Upper the frame and pull it forward as shown in
the figure.
Accessory➁
Removal tool
2
When the upper level is removed, remove the
lower two locations.
• The frame can be removed from the bottom side in the
same manner.
32
|
English
Lock
Catch
Removing the Unit
1
Refer to the section 'Removing the hard rubber
frame' (page 32) and then remove the hard
rubber frame.
2
Remove the screw (M4 × 8) on the back panel.
3
Insert the two removal tools deeply into the slots
on each side, as shown.
Screw (M4X8)
(commercially available)
4
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
• Be careful to avoid injury from the catch pins on the
removal tool.
5
Pull the unit all the way out with your hands,
being careful not to drop it.
Accessory➁
Removal tool