Audio Setup; Speaker Setting; Audio Control - Kenwood KDC-MP338 Instruction Manual

Audio Setup
You can set Sound system, such as follows;
- - - -
Front High Pass Filter* "HPF" Through/40*'/60*'/80/100/120/
1501180/220*' Hz
Rear High Pass Filter* "HPR" Through/40*1/60*1/80/100/120/
1501180/220*' Hz
Low Pass Filter "LPF SW" 50*'/60*1.2/801100*1/1201160*3/
Through Hz
Subwoofer Phase* "PHASE" Reverse (180°)/ Normal (0°)
Volume offset "V-OFFSET" -8 - ±O (AUX: -8- +8)
Loudness* "LOUDNESS" OFF/ON
Dual Zone System* "2Z0NE" OFF/ON
*Function of KDC-X492/KDC-MP438U/KDC-MP408U.
*lKDC-X492 only. *2KDC-MP438U/KDC-MP408U only.
*3KDC-MP338 only.
~
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Loudness: Compensates for low and high tones during
low volume. (Only the low tone is compensated for
when the tuner is selected as a source.)
Dual lone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "lONE2" of <Menu
System> (page 12).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by Control knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 6) or
[.~]I[T]
button on the remote control
(page 15).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the Control knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the Control knob.
4
Adjust the Audio setup item
Turn the Control knob.
S
Exit Audio Setup mode
Press the Control knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System
Q
value is optimal
when setting the speaker type as follows;
11."""""_-
OFF "SP SEL OFF"
For 5&4in. speaker "SP SEL 5/4"
For 6
&
6x9 in. speaker "SP SEL 6*9/6"
For the OEM speaker "SP SEL OEM"
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the Control knob.
3
Select the Speaker type
Turn the Control knob.
4
Exit Speaker Setting mode
Press the Control knob.
English
I
7