Connecting Wires To Terminals - Kenwood DPX502 Instruction Manual

Connecting Wires to Terminals

To connect these leads, refer to the
⁄
relevant instruction manuals.
To Kenwood disc changer/
External optional accessory
Fuse (10A)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Wiring harness
(Accessory1)
If no connections are made, do not let the wire come out from the tab.
White
White/Black
FRONT L
Gray
Gray/Black
FRONT R
Green
Green/Black
REAR L
Purple
Purple/Black
REAR R
FM/AM
antenna input
Front left output (White)
Front right output (Red)
Rear left output (White)/ Sub Woofer left output (White)
Rear right output (Red)/ Sub Woofer right output (Red)
When using the optional power amplifier, connect
P.CONT
to its power control terminal.
Depending on what antenna you are using, connect
either to the control terminal of the motor antenna, or
ANT.
to the power terminal for the booster amplifier of the
CONT
film-type antenna.
Connect to the terminal that is grounded when either
the telephone rings or during conversation.
MUTE
⁄
To car light control switch
ILLUMI ILLUMI
To front left
speaker
To front right
speaker
To rear left
speaker
To rear right
speaker
Car fuse box
ACC
To connect the Kenwood navigation
system, consult your navigation manual.
Ignition key
switch
Car fuse box
(Main fuse)
+
–
Battery
33
|
English