Alarm Recording - Q-See QSNDVR4R Manual

Check recording parameter setup before recording; select video quality, frame rate. you
cannot change record setting during the process of recording.
Manual recordings belong to normal recording. Under the manual mode (non-schedule
status), here pushing record button will record all channels' image video.
Push the record button to begin recording, four channels will start simultaneously
recording. While in normal recording mode, push record or stop button, and enter the right
password, it will stop recording.
During the process of recording, if the hard disk is full, and the system is set to automatic
overwrite, then the recording will not be interrupted, and it begins to overwrite from the
earliest recorded area; if the system is set to overwrite disable, it will stop recording.

4.Alarm Recording

Alarm recording is not started by manually pushing record button, all the recording
started by manually pushing the record button are normal record.
Alarm recording can be activated by alarm input signal or motion, so it must to check
whether the connection of alarm input equipment is correct, stable and reliable, and the
alarm set is right.
The prerequisite condition of whether the alarm recording can be activated by exterior
input signal or the motion is that the system must be set on schedule and that period is set to
"A" in record schedule setup, also, in the menu of alarm setup, for exterior input alarm,
alarm enable of that channel must set to "ON", for motion alarm, motion enable of that
channel must set "ON", and set the right area for motion detect.
Under the state of off-schedule, system will never start alarm recording. Setting schedule
on or off is achieved through pushing the schedule button on the front panel, but not through
system setup menu and window. Under schedule-on situation, the character "S" will display
on the screen.
Alarm video recording cannot stop by pushing record or stop button, but can stop by
removing schedule. Because once the system is set on schedule, the schedule cannot be
removed randomly, so there is a password protection to remove schedule, only after
inputting correct password, you can take schedule off.
Check alarm recording setup before recording; confirm the video quality and the frame
rate, the record setting cannot change during recording process.
As long as the alarm input signal is effective, the alarm recording continues. When the
alarm input signal loses efficacy, the time set up by "A/M REC TIME" becomes effective,
and when the time goes out, the alarm recording automatically stops. In course of this, if
you want to manually stop alarm recording, the only way is to remove schedule (answer the
password).
4 Channel Digital Video Recorder
26