Relay Recording (Ct-2050/Kxf-W6010 Only); Relay Recording - Kenwood CT/KXF-W Instruction Manual

Relay recording (CT-2050/KXF-W6010 only)

This function allows to record sound continuously from deck
A to B.
Since this unit is not designed for recording with metal
(TYPE ) tapes, do not use metal tapes for recording.
Preparation
Make "Playback (recording) preparation".
(If relay recording is required, insert tapes
in both decks A and B. Select the record-
ing mode to set to "O" or "[" only.)

Relay recording

1
Set the relay recording mode.
2
Perform auto-bias adjustment. (The bias adjustment is applied to deck B.)
3
Adjust the recording level.
1
Play the music source.
2
Set the record-pause mode. (deck A).
3
Adjust the recording balance and record-
ing level.
4
Stop playing the music source.
4
Start recording.
1
Press the REC/ARM (¶) key (of deck A).
2
Play the music source from the begin-
ning.
To cancel relay recording
Relay recording cannot be performed if the REV.MODE key is set to """.
Note Note
0
RELAY REC
AUTO BIAS
^
¶
REC/ARM
RELAY REC
: Keys and control used in the operations described on this page.
"RELAY" lights up.
"AUTO BIAS"blinks. After approximately
40 seconds
÷ The optimum bias is set in about 40 seconds, after which the deck
enters the stop mode.
÷ Recording is possible even if the auto-bias adjustment operation is
omitted.
÷ Recording will start.
÷ Recording on deck B starts immediately after recording on deck A has
completed.
"RELAY" goes off.
÷ Press the RELAY REC key again.
CT-2050/203/KXF-W6010/W4010 (En/M)
"AUTO BIAS" lightsup.
19