Kenwood CT/KXF-W Instruction Manual page 18

18
To pause recording temporarily
Pause
8
PAUSE
÷ The 8 indicator lights.
How to provide non-recorded blanks between programs
In stop mode
Press successively twice.
¶
REC/ARM
To start recording again from the biginning
The following procedure is useful when you want to cancel recording in progress and re-start it.
A non-recorded space of about 4 seconds or more should be reserved before the position where recording was started.
1
2
CT-2050/KXF-W6010
CT-203/KXF-W4010
3
4
To resume recording
¶
REC/ARM
During recording
Press once.
¶
REC/ARM
Rewind during recording.
During recording in the 3 direction:
1 ¡
During recording in the 2 direction:
1 ¡
Press the REC/ARM (¶) key twice.
¶
REC/ARM
Replay the tune you wish to record.
Press the REC/ARM (¶) key once.
¶
REC/ARM
How to record (CT-203/KXF-W4010; Deck B only)
To stop recording
1
Stop the tape transport.
CT-2050/KXF-W6010
CT-203/KXF-W4010
2
Stop playing the source component.
÷ After leaving a non-recorded blank of about 4 seconds, the deck enters
the record-pause mode.
÷ When the ¡ (or 1) key is pressed during recording, recording is
aborted and tape is rewound as shown below if there is a non-recorded
space of more than 4 seconds before the recording start position.
Tape stops after 2 sec.
of transport.
Recorded tune
Blank of 4 sec. or more.
÷ If there is no recorded tune before, the tape will be rewound then
stopped.
÷ When re-recording from the beginning of tape, feed the leader tape (the
first portion of tape that cannot be recorded) before starting re-
recording.
÷ A non-recorded space of about 4 seconds is reserved on tape, then the
tape transport stops.
÷ Recording starts.
CT-2050/203/KXF-W6010/W4010 (En/M)
2 7 3
Re-recording
Tune to be re-recorded.