Chapter 2: Features / Systems
Line 2 Transfer switch (Dual Shore Power Only)
• When using the "Line 2 Transfer Switch" do not exceed 30 total amps.
• The amperage of each component breaker is shown in figure 1, on the previous page.
• The voltage on each line can be read by setting the voltmeter selector switch.
When only one dockside outlet is available, you
can use the "Line 2 Transfer Switch" to provide
power to both lines.
1. Connect to shore power as described in steps
1 through 4 above.
2. Switch the "Line 2 Transfer Switch" On
instead of the "Line 2 Dockside Master".
3. Turn On the individual component breakers
as required.
20
NOTICE
AC PANEL (IF EQUIPPED)
265 • Owner's Manual Supplement
LINE 2
TRANSFER
DUAL SHORE POWER
SWITCH