Connecting To Shore Power; Parallel Switch (If Equipped With Dual Shore Power) - Bayliner 305 Owner's Manual

Chapter 12: Electrical System
• The single shore power 110-volt/60-hertz AC system features one 110-volt/30-amp shore power receptacle.
• If your boat has an air conditioning system, a second (dual) 110-volt/30-amp inlet has been installed.
• Dual shore power inlets are labeled "LINE 1" and "LINE 2", which corresponds to the "SHORE POWER 1" and
"SHORE POWER 2" master breakers on the 110-volt AC master panel.
• LINE 1 and LINE 2 are independent of each other except when using the parallel switch.

Connecting to Shore Power

SHOCK & ELECTRICAL SYSTEM DAMAGE HAZARD!
• Monitor the polarity indicator lights every time you connect to shore power.
• If a reversed polarity light turns On when you are connecting to shore power, do NOT turn
On the main breaker switches.
• Instead, immediately unplug the shore power cord (always from the dockside outlet first)
and alert marina management.
1. Review all hazard information at the beginning
of this section, Shore Power.
2. Turn Off the shore power master circuit
breaker(s) and all switches and breakers on the
110-volt AC master panel.
3. Attach the shore power cord(s) to the boat
inlet(s) first, then to the dockside outlet(s).
4. Turn On the "SHORE POWER 1" and "SHORE
POWER 2" (if equipped) master breaker(s) on
the 110-volt AC master panel.
5. On the 110-volt AC master panel turn On the
individual component breakers as needed.

Parallel Switch (If Equipped with Dual Shore Power)

• When using the parallel switch do NOT exceed 30 total amps.
• The amperage of each component breaker is shown on the breaker itself.
• The voltage on each line can be read on the voltmeter on the 110-volt AC master panel.
When only one dockside outlet is available, you can use the Parallel Switch to provide power to both lines.
1. Connect to shore power as described in the section "Connecting to Shore Power" earlier in this chapter.
2. Switch the Parallel Switch On instead of the "SHORE POWER 2" master breaker.
3. Turn On the individual component breakers as required.
64
! WARNING!
TYPICAL SHORE
POWER INLET
NOTICE
305 • Owner's Manual Supplement
SHORE POWER INLET(S)