Table of Contents
Advertisement
10.
Set the Power Switch to ON.
NOTE
Use the above procedure to clear paper jam when using continuous form-
front push.
R
ESPONDING TO ALARM CONDITIONS
Use the following table for guidance on how to respond to indicated alarm conditions.
INDICATOR
SEL
OFF
OFF
OFF
Flashing
Flashing
R
ESPONDING TO GENERAL PROBLEMS
Use the following table to help you to identify symptoms with possible causes and take
suggested remedial actions.
PROBLEM
No power
No power
No printing takes place
SEL indicator is unlit.
SEL indicator is illuminated
but no printing takes place.
The print head is moving but
no printing takes place.
ALARM
ON
Paper has run out. Add paper and press the SEL button.
Flashing
The Paper Type lever is wrongly set for the type of paper in
use. Press the SEL button and set the Paper Type lever to the
correct position.
Flashing
Problem with cut sheet feeding. Remove the cut sheet.
ON
Print data is received but printing does not start because no
paper is being fed. Insert paper.
Flashing
Printing cannot be resumed at this stage. Turn the power OFF,
verify that the carriage moves properly, then turn the power
ON again.
If the problem is still there after you turn the power ON again,
contact your dealer.
CAUSE
The power cable is not
properly connected.
Power outlet problem or
power outage.
The printer driver is not
installed properly.
The printer has just stopped
printing.
There is no paper in the
printer.
Interface cable is
disconnected.
Wrong interface cable has
been used.
The ribbon cartridge has not
been installed.
Troubleshooting > 62
ALARM MEANINGS AND ACTIONS
ACTION
Check the power cable is
properly connected at both
power outlet and printer.
Plug another appliance into
this outlet to check if it
works.
Re-install the printer driver
correctly.
Press the SEL button.
Load paper.
Reconnect the interface
cable.
Use correct interface cable.
Install the ribbon cartridge.
Advertisement
Table of Contents
