Advertisement
• The burner settings are;
1/IGN...........Centre section on low. Outer sections off.
2....................Centre section fully on. Outer sections off.
3....................Centre section fully on. Outer sections on low.
4....................Centre section fully on. Outer sections fully on.
• We recommend that the fire is set at position 4 for the first 10 minutes after lighting to
warm up the chimney and so obtain full efficiency quickly.
• If operating the appliance for long periods it is beneficial occasionally to change the
settings. This will also help to remove any carbon deposits that may form during
operation.
Note: If the fire goes out while setting the control, repeat the full lighting procedure. If
the fire repeatedly goes out, have the fire serviced.
To turn the fire off
• Partially depress the control knob and turn clockwise to OFF. Release the knob.
• Wait at least 3 minutes after turning the fire off before relighting.
Lighting with a taper
In the unlikely event of failure of the
ignition spark, the pilot can be lit with a
taper or long spill after the window
surround and window unit have been
removed. Removal of these parts is
described in the "Cleaning Window
Glass" chapter on the next page.
Insert the taper or spill into the centre
opening in the ceramic coal while the
control is kept depressed at the 1/IGN
position. See figure 3.
When the pilot has lit follow the rest of
the instructions in the instructions
headed "To light the fire". Always
replace the window unit after
lighting.
OWNER'S GUIDE
Figure 3 Lighting with a taper
Page 7
Advertisement
