Mounting - Ganz C-AllView Installation Manual

Mounting

The Camera unit is designed to be mounted upright or inverted. By the nature of its
manufacture, it is a heavy item, thus it requires a substantial and stable mounting.
Each Camera unit is supplied with a 4" (101.6mm) PCD mounting adaptor to allow
mounting to industry standard brackets, tower and columns.
The adaptor as two cable entry points:
1. A pass-through hole in the plate to allow cabling through a column or tube
type mounting.
2. A M25 conduit thread in the side wall to permit flexible conduit to be
connected to the adaptor.
This adaptor should have the composite cable threaded through it before it is
mounted to the column or bracket. The cable should be dressed such that approx
25~35mm of the weatherproof connector is protruding out of the smaller plate that
connects to the Camera unit.
The 4" (101.6mm) PCD plate should then be mounted to bracket or tower using M8
bolts, washers and Ny-Loc type nuts.
Figure 1
Figure 2
5