Rear Panel Description - Phonic XP 600 User Manual

REAR PANEL DESCRIPTION

8 FAN
These two variable speed fans automatically maintain
safe internal temperature. Keep the front and rear vents
clear to allow full airflow. Hot air will be drawn out the
back of the amplifier, so it does not stay in the rack,
and make sure plenty of cool air can enter the rack.
9 RESET BREAKER (XP2000/2100 & XP 3000
/3100 ONLY)
With rated loads and output levels, the breaker should
only shut down the amplifier in rare instances of cata-
strophic failure. The circuit breaker can also shut down
the amplifier in cases where extremely low-impedance
loads and high output levels result in a current draw
that exceeds its rating.
8
10 POWER CORD
All units are shipped with an appropriate plug and cord
for the required AC voltage. This product is equipped
with a 3-wire grounding type plug. This is a safety
feature and should not be defeated. Check the AC
voltage before connecting the plug.
11 CHASSIS GROUNDING CONNECTING
POINT
Please refer to your local safety code for proper ground-
ing.
12 OUTPUT CONNECTORS
A pair of versatile binding posts and Speakon connec-
tors are provided for output connection to each chan-
nel. Loudspeakers can be easily connected using
banana plugs, spade lugs, bare wires or Speakon
connector. Spade lugs and bare wires should both be
screwed down tightly to avoid a short circuit. The
Speakon connector for channel 1 includes channel 1,
channel 2 and bridged mono pin connecting points. A
pin out information could be foundbeside the Speakon
connector.
XP 600/1000/2000/2100/3000/3100