Product Overview; Rear Panel; Connections - Phonic MAX 1000 User Manual

Hide thumbs Also See for MAX 1000:

Table of Contents

Available languages

PRODUCT OVERVIEW

1. HEAT VENTILATION

This unit comes with variable speed fan that auto-adjusts

fan speed depending on the temperature of the machine

during operation. Be sure not to obstruct the heat vents in

any way. This will ensure the amplifier is always properly

ventilated.

2. INPUT

With these balanced XLR and 1/4" input jacks, you can use

any XLR or 1/4" phone jack connector. These input jacks

accept balanced and unbalanced inputs. When sending

unbalanced signals, the 3rd pin and the 1st pin of the XLR

connector should be connected (see Figure 2).

MAX 1000

3. OUTPUT

Binding posts and speakon connectors make up the unit's

output section. Loudspeakers can easily be connected

using banana plugs, spade lugs, bare wires or speakon

connector. More people prefer using speakon than other

connectors because it's the least likely to be disconnected

by accident or cause electrical shock. Because speakon

comes with four wires inside, you can connect to two speak-

ers with only one channel output. Be careful when making

connections since improper connecting could cause the

unit to short circuit. The minimum impedance setting for

STEREO and PARALLEL operation is 4 ohm, while 8 ohm

is the minimum for BRIDGE MONO (see Figure 3).

Figure 3 Output Wiring

Table of Contents

Table of Contents