Table of Contents
Advertisement
Available languages
Available languages
English
10. Bundling the cables.
Speed clamps and bead band are included with the
plasma television for tidying your cables and keeping
extra cable length out of the way.
Attaching speed clamps to the plasma television
Attach the speed clamps using the holes marked with
below, depending on your routing system.
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the
plasma television and snap [2] into the back of [1] to
lock the clamp.
1
• Speed clamps are designed to be difficult to undo
once in place. Please attach them carefully.
• Use pliers to twist the clamp 90°, pulling outward.
The clamp may deteriorate over time and become
damaged if removed.
• Be careful not to subject any connecting cables to
strain.
NOTE:
• Use the bead bands and speed clamps as
necessary.
• When tidying up your speaker cables, make sure to
bundle them so that they are not subjected to any
pressure.
Speaker Cable
∞ Rear of Display
Speed Clamp
Bead Bands
6
2
Speed Clamp
Speed Clamp
When using the hung on wall unit:
NOTE:
First lay the plasma television on top of a soft sheet etc.,
then attach the speakers.
1. Attach the speakers to the plasma
television (See procedures 1 to 10 on
pages 3 to 6).
2. Place the plasma television on the
mounting fittings of the hung on
wall unit.
For details, refer to the operating instructions supplied
with the hung on wall unit.
Caution
Do not lift up the display by the speakers. A speakers
may come off, so hold it by the bottom and top.
Advertisement
Table of Contents
