Remote Control (Optional Accessory) Setup; Remote Control Id Setup; Remote Control Id Delete; Dual Zone Control Setup - Kenwood KMR-700U Instruction Manual

Remote control (Optional accessory) setup

Remote control ID setup

When connecting the remote control KCA-RC107MR
(Optional accessory) to this unit, you should register
the ID for KCA-RC107MR.
1
Enter Remote control setup mode
Press the [2ZONE] button for at least 1 second.
2
Select the Remote control ID setup item
Turn the [VOL] knob to select "Remote ID Set",
and then press the [ENTER] button.
Remote control ID list is displayed. "Yes" indicates
that this ID is already registered. "No" indicates that
this ID is available.
3
Enable Remote control ID registration
Press the [ENTER] button.
"Registering... " is displayed.
4
Register Remote control ID
For KCA-RC107MR, press the [ENTER], [SRC], or
[DISP] button.
Button Remote control ID
[ENTER] ID1 is registered.
[SRC] ID2 is registered.
[DISP] ID3 is registered.
"ID# Setup Completed" is displayed.
5
End Remote control setup mode
Press the [2ZONE] button.
Cancelling Remote control ID setup
Press the [2ZONE] button for at least 1 second.
⁄
• When removing KCA-RC107MR, delete the registered
remote control ID, as described in <Remote control ID
delete> (page 20).
20
|
KMR-700U

Remote control ID delete

Delete the ID registered for the remote control KCA-
RC107MR (optional accessory).
1
Enter Remote control setup mode
Press the [2ZONE] button for at least 1 second.
2
Select the Remote control ID delete item
Turn the [VOL] knob to select "Remote ID
Delete", and then press the [ENTER] button.
List of the IDs registered for remote controls is
displayed.
3
Select the remote control ID to be deleted
Turn the [VOL] knob.
4
Delete the Remote control ID
Press the [ENTER] button.
"Remote ID# Delete?" is displayed.
5
Turn the [VOL] knob to select "YES", and then
press the [ENTER] button.
"ID# Delete Completed" is displayed.
6
End Remote control setup mode
Press the [2ZONE] button.
Cancelling Remote control ID delete
Press the [2ZONE] button for at least 1 second.

Dual zone control setup

When the dual zone function is set to ON, select the
channel, either front or rear, to be controlled by the
remote control KCA-RC107MR (optional accessory).
1
Enter Remote control setup mode
Press the [2ZONE] button for at least 1 second.
2
Select the Dual zone control setup item
Turn the [VOL] knob to select "Remote Zone
Select", and then press the [ENTER] button.
Current settings are displayed for the registered
remote control IDs.
3
Select the target remote control ID
Press the [u] or [d] button.
4
Select the target channel
Press the [ ] or [
Display Controlled channel during dual zone mode
"Front" Front channel is controlled.
"Rear" Rear channel is controlled.
5
End Remote control setup mode
Press the [2ZONE] button.
] button.