Kenwood KMR-700U Instruction Manual page 27

The messages shown below display your
systems condition.
Protect (Blink):
The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
➪ Wire or insulate the speaker cable properly
and press the reset button. If the "Protect"
code does not disappear, consult your
nearest service center.
No Device: The USB device is selected as a source
although no USB device is connected.
➪ Change the source to any source other
than USB. Connect an USB device, and
change the source to USB again.
N/A Device: • An unsupported USB device is connected.
• Connection to the iPod has failed.
➪ Check that the connected iPod is an iPod
that is supported. See <About Audio file>
(page 21) for information on supported
iPods.
No Music Data/No Music:
• The connected USB device contains no
playable audio file.
• Media was played that does not have data
recorded that the unit can play.
USB Error: Some trouble may have occurred to the
connected USB device.
➪ Remove the USB device, then cycle the
power switch to ON. If the same display is
repeated, use another USB device.
REMO ERROR: Some trouble may have occurred to the
connected Remoto control.
➪ Remove the Remoto control and then
reconnect it.
USB REMOVE (Blink):
The Remove mode has been selected for the
USB device. You can remove the USB device
safely.
iPod REMOVE (Blink):
The Remove mode has been selected for the
iPod. You can remove the iPod safely.
FAV : No Memory:
The procedure is not registered to Favorite
Preset Memory
NO ACCESS: The procedure preset with Favorite Control
cannot be available. The preset content may
not be recalled depending on the selected
source or mode.
27
|
English