Ir Transmission Delay - ROHS ITX-i9453 User Manual

Extrnal FDC Controller
Select "Enabled" if your system has a floppy disk controller (FDC) installed
and you wish to use it. Select "Disabled" if your system has an add-in FDC
or has no floppy drive.
Setting: Disabled, Enabled (Default).
Onboard Serial/Parallel Port
It allows you to select the onboard serial and parallel ports with their
addresses.
Setting:
UART Mode Select
It determines the UART 2 mode in your computer.
Setting: IrDA, ASKIR, Normal (Default).
RxD, TxD Active
Setting: Hi,Hi , Hi,Lo (Default) , Lo,Hi , Lo,Lo.

IR Transmission Delay

Setting: Disabled, Enabled (Default).
UR2 Duplex Mode
Setting: Full, Half (Default).
Use IR Pins
Setting: RxD2,TxD2 , IR-Rx2Tx2 (Default).
ITX-i9453 User's Manual
Serial Port 1
Serial Port 2
Parallel Port
3F8/IRQ4 (Default)
2F8/IRQ3 (Default)
378/IRQ7 (Default)
BIOS
43