Connecting Wires To Terminals - Kenwood KDC-MP928 Instruction Manual

Connecting Wires to Terminals

Subwoofer right output (Red)
Subwoofer left output (White)
Wiring harness
(Accessory1)
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
Power control wire (Blue/White)
Motor antenna control wire
(Blue)
TEL mute wire (Brown)
Dimmer control wire
(Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Rear right output (Red)
Rear left output (White)
Front right output (Red)
Front left output (White)
AUX right input (Red)
AUX left input (White)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse box
ACC
When using the optional power amplifier, connect to its power
control terminal.
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal for
the booster amplifier of the film-type antenna.
Connect to the terminal that is grounded when either the telephone
rings or during conversation.
To connect the KENWOOD navigation system, consult your
navigation manual.
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
Car fuse box
(Main fuse)
Battery
To KENWOOD disc changer/
External optional accessory
To connect these leads, refer to the
relevant instruction manuals.
FM/AM antenna input
57
|
English