Notes - Kenwood KDC-MP928 Instruction Manual

Notes

• If you experience problems during installation,
consult your Kenwood dealer.
• If the unit fails to operate properly, press the Reset
button to restore factory settings.
• Press the reset button if the disc auto changer fails
to operate correctly. Normal operation should be
restored.
Reset button
• We recommend the use of <Security Code>
(page 44) to prevent theft.
• The characters conforming to ISO 8859-1
character set can be displayed.
• There are places in this manual where lit
indicators are described; however, the only time
an indicator will light is in the following settings.
When Indicator is selected as mentioned in <Text
Display Switching> (page 22)
• The illustrations of the display and the panel
appearing in this manual are examples used to
explain more clearly how the controls are used.
Therefore, what appears on the display in the
illustrations may differ from what appears on the
display on the actual equipment, and some of the
illustrations on the display may be inapplicable.
Cleaning the Unit
If the faceplate of this unit is stained, wipe it with a
dry soft cloth such as a silicon cloth.
If the faceplate is stained badly, wipe the stain off
with a cloth moistened with neutral cleaner, then
wipe it again with a clean soft dry cloth.
• Applying spray cleaner directly to the unit may affect its
mechanical parts. Wiping the faceplate with a hard cloth
or using a volatile liquid such as thinner or alcohol may
scratch the surface or erases characters.
Cleaning the Faceplate Terminals
If the terminals on the unit or faceplate get dirty,
wipe them with a clean soft dry cloth.
Before using this unit for the first time
This unit is initially set on the Demonstration mode.
When using this unit for the first time, cancel the
<Demonstration mode Setting> (page 52).
About ODD (Offset Dual Differential) D/A
System
You can enjoy high quality sound play when
playing music CDs with the ODD D/A System
enabled. ODD D/A System has two built-in D/A
converters and each D/A converter processes D/A
conversion seperately on the front left and right
channel. Since digital processing is performed for
each channel seperately, noise occurance from
interference between channels is completely
suppressed and the seperation of audio sound
output from two channels is distinguished and
clear. Also, the ODD/A System produces the data
by which the sound data is offset on the minus side
and converts the two signals (original and offset
data) to the analog signal, which has less noise and
distortion, by the synthetic process.
However, ODD D/A System will be disabled if the
following settings are selected.
- When "2ZONE" of <Audio Setup> (page 11) is
"ON".
- When <Bypass Control> (page 16) is "Bypass".
5
|
English