Audio Control; Audio Setup - Kenwood KDC-MP928 Instruction Manual

Audio Control

1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display
1
Rear Volume * "REAR VOLUME" 0 — 35
Subwoofer level* 2 * 3 "SW LEVEL"
Balance "BALANCE"
Fader* 3 "FADER"
Exit Audio Control mode
• * 1 You can control this item when "2ZONE" of <Audio
Setup> (page 11) is set to "ON".
• * 2 You can control this item when Speaker Select
Subwoofer of <Sound Management system> (page
13) is set to any item other than "None".
• * 2 You can control this item when <Subwoofer
Output> (page 12) is set to "SUBWOOFER ON".
• * 3 You can control this item when "2ZONE" of <Audio
Setup> (page 11) is set to "OFF".
5
Exit Audio Control mode
Press the [AUTO] or [NEXT] button.

Audio Setup

Setting the Sound system, such as Volume offset
and Dual Zone.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Range
–15 — +15
Left 15 — Right 15
Rear 15 — Front 15
5
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Volume offset "VOLUME OFFSET" –8 — 0
Dual Zone System "2ZONE"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 48).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by <Audio
Control> (page 11).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the Auxiliary
input sources listed below.
- Internal auxiliary input
• You can use the Dual Zone System only when you
have set the rear speaker to any mode other than
"None" in the <Sound Management system> (page
13).
• When the "2ZONE" is ON, ignore the following setups.
- <Sound Field Control> (page 12)
- <Sound Management system> (page 13)
- <Equalizer Control> (page 14)
- <WOW Control> (page 15)
- <Bypass Control> (page 16)
• ODD D/A System is not effective when the "2ZONE" is
ON.
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Range
ON/OFF
11
|
English