Superimpose Tab; Installation Tab - Sony Ipela SNC-CH140 User Manual

OK/Cancel
See "Buttons common to every menu" on page 26.

Superimpose Tab

Select whether to superimpose the camera ID, date &
time and other information on the image or not.
The camera ID is also superimposed on images recorded
by the Pre-alarm or Post-alarm function.
Superimpose
On/Off
When using the Superimpose function, select On.
Font size
Set the font size.
Style
Set the items to superimpose and the format to display
in. Superimpose settings are available for the following
items:
• Date: Set the display settings for date and time.
• Camera ID: Set the display settings for Camera ID
and string.
• Event: Configure the display setting for when an
event occurs.
• Codec: Configure the bit rate and frame rate display
settings. Displays the codec information for Image 1.
• Custom string: Set Custom string to display the text
of your choice.
Display format, including color, can be individually set
for each item.
Color: Select the font color of the superimposed text.
Blink: Select On to enable blinking for the
superimposed text. However, the blinking display is
not available for Date.
String Effect: Enable a string effect for displayed text.
Advanced: Click the Setting button in Date to
configure the format of date/time and the separator.
Click the Setting button in Camera ID to configure
the Camera ID string setting and upload Logo.
Images that can be used as a Logo must be in gif89a
format with an image size up to 640 × 120. The
number of pixels horizontally is even numbered and
the maximum file size is approximately 50 KB. The
Camera ID string and logo can not be used at the
same time.
Superimpose format
Click Edit to edit the content to superimpose over each
display position.
Only one Date and one Camera ID can be specified for
the Superimpose format.
You can set the content to superimpose in the bottom
left, bottom right, top left, top right, center, top middle,
and bottom middle parts, respectively. However, if you
specify the top middle, superimposed content will not
appear on the top left or top right. Similarly, if you
specify bottom middle, superimposed content will not
appear on the bottom left or bottom right.
Click Date & Time, Camera ID, Codec or Event to
insert the corresponding tag into the string.
OK/Cancel
See "Buttons common to every menu" on page 26.

Installation Tab

You can perform settings related to installation.
Maximum image size
1280 × 720: Image will have an aspect ratio of 16:9, and
an image size up to 1280 × 720 can be specified for
the video codec.
1280 × 1024: Image will have an aspect ratio of 5:4, and
an image size up to 1280 × 1024 can be specified for
the video codec.
Notes
• The camera restarts when the Maximum image size is
changed. It takes about 2 minutes.
• The settings below are changed when the Maximum
image size is changed.
– Camera menu-privacy mask tab: returns to the
factory setting.
– Camera menu-video codec tab: returns to the factory
setting except:
– Image size of image1: to be 1280 × 720 when set
to 1280 × 720, or 1280 × 1024 when set to
1280 × 1024.
– Frame rate of image1: to be 30fps when set to
1280 × 720, or 20fps when set to 1280 × 1024
– Alarm buffer menu: returns to the factory setting.
– Event detection menu- motion detection tab: returns
to the factory setting except:
– Maximum detection size of motion diction: to be
width of 1280 and height of 720 when set to
1280 × 720, or 1280 and height of 1024 when set
to 1280 × 1024.
Configuring the System — System Menu
29