Control Bar - Sony Ipela SNC-CH140 User Manual

Monitor screen
(Pan/tilt/zoom functions are not available for this
model.)
The image shot by the camera is shown here.
There are two modes for on-screen pan/tilt/zoom
operation using a mouse: Area zoom mode and Vector
dragging mode. A control bar is displayed on the screen.
In the Area zoom mode, clicking will pan or tilt the
camera towards the center of the image. The Area zoom
will move the camera in the direction that displays the
area selected by the operator and zooms in at the same
time. The operator can choose a part of the image to
view and zoom in by surrounding the area with a frame
by dragging the mouse.
In the Vector dragging mode, the camera pans or tilts in
the dragged direction. How long you drag the mouse
determines the speed. Releasing the button on the mouse
after dragging stops the panning or tilting of the camera.
You can also use the tool bar to pan or tilt. The zoom
operation using the mouse wheel is available in all
modes.

Control bar

The following operation buttons are available.
Setting
You can set the streaming method, image size,
frame rate, PTZ operation mode (Not available with
this product), and trigger selection.
Streaming start button
Starts streaming. (Appears while stops streaming.)
Streaming stop button
Stops streaming. (Appears while streaming.)
Trigger run button
Runs the selected trigger.
Preset (Not available with this product.)
Select a preset position to move the camera to the
registered preset position.
(Displayed only when a camera preset position is
registered.)
20
Configuration of Main Viewer
Save still image button
Captures still images taken by the camera and saves
them to the computer.
Audio output volume slider
Use the slider to adjust the volume. Clicking the
button will stop sound output.
(Displayed only when ActiveX is set for
Streaming method in Setting, and Microphone
in the Camera Menu (page 31) is set to On.)
Control waiting time and control time for exclusive
control
Exclusive control button (Not available with this
product.)
Camera list
The camera list is displayed when Camera list is set to
On in the viewer menu, and at least one camera is
registered.