Connecting Wires To Terminals - Kenwood KDC-MP528 Instruction Manual

Connecting Wires to Terminals

KDC-X589
Front left output (White)
A
Front right output (Red)
Rear left output (White)
B
Rear right output (Red)
Sub Woofer left output (White)
C
Sub Woofer right output (Red)
To KENWOOD disc changer/
External optional accessory
To connect these leads, refer to the
relevant instruction manuals.
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its
power control terminal.
Depending on what antenna you are using, connect either
to the control terminal of the motor antenna, or to the
power terminal for the booster amplifier of the film-type
antenna.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
To connect the KENWOOD navigation system,
consult your navigation manual.
To "EXT.AMP.CONT. " terminal of the amplifier having
the external amp control function.
KDC-MP5028/MP528
Front left output (White)
Front right output (Red)
Rear left output (White)/
Sub Woofer left output (White)
Rear right output (Red)/
Sub Woofer right output (Red)
AUX left input (White)
AUX right input (Red)
Fuse (10A)
To car light control switch
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
B
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
External amplifier control wire
(Pink/Black) (KDC-X589 only)
Dimmer control wire (Orange / White)
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse box
ACC
Ground wire (Black) · (To car chassis)
C
A
FM/AM antenna input
Wiring harness
(Accessory1)
Ignition wire (Red)
Battery wire (Yellow)
English
33
|