Clean The Rollers And Glass - Avision FS-0913B User Manual

Notice:
Do not interrupt the calibration sequence or try to shut off the device while it is
calibrating. If you stop the calibration before it has completed, a calibration error may
occur. As a result, when you next power up the unit E06 may be displayed on the LCD
screen. If this happens, please calibrate the scanner again.
Calibrate the scanner only when the image looks fuzzy or white color needs adjustment.
Ensure the battery is fully charged.
Ensure the memory card is inserted.
Keep the calibration sheet from dust and debris. Any dirt may make the calibration chart
invalid or impact the calibration result.
Use only the included calibration sheet to calibrate the scanner.

4.2 Clean the rollers and glass

if vertical lines or stripes appear on the scanned image, it is possible that there is dust or
debris on the rollers or the glass. Clean the rollers and glass with included cleaning cloth.
Use only the included cleaning cloth to clean the scanner glass.
Cleaning steps:
1. Turn the scanner over to reveal the rollers and glass.
2. Wipe the rollers and the glass with the included cleaning cloth as illustrated.
Note:
Adding some isopropyl alcohol (95%) on the cleaning cloth is more efficient when
cleaning the rollers.
Do not use any solvents or corrosive liquid (i.e., alcohol, kerosene, etc.) to clean any
part of the scanner, otherwise the plastic material will be permanently damaged.
Make sure the surface of the document or photo doesn't have any paper clips, etc. or
this could damage the scanner glass lens.
4-2
Rollers
Glass