CLEANING & MAINTENANCE
After use, wait for the unit to cool properly before cleaning and storing.
•
Wipe the inside and edges of the cooking plates with absorbent paper towel
•
or a soft cloth.
Should any filling be difficult to remove, pour a little cooking oil onto the cooking plate and
•
re-heat the unit for two minutes. Wait for the unit to cool for five minutes then try to remove
the filling again.
Always remember to unplug the unit from the power outlet when not in use and before
•
cleaning.
The body of the appliance should be cleaned with a damp cloth. Do not allow water to enter
•
the appliance.
Do not use bleach, abrasive substances or solvents to clean your appliance as these can be
•
damaging to the finish.
To remove stubborn spots/marks, wipe the surfaces with a cloth slightly dampened in
•
soapy water or mild non-abrasive cleaner. Rinse and dry, with
a clean soft cloth.
REMOvING THE GLASS PANEL
To clean under the glass panel, the panel can be removed.
•
Place the Panini Press on a firm, level surface.
•
Use your fingers to unscrew the screws at the corners of the glass.
•
CAUTION: Do not use pliers or other tools and they will damage the screws
and may break the glass.
Remove the fibre washers, making sure they do not get lost.
•
Lift the glass panel up, and wash with warm soapy water, and dry thoroughly.
•
Place the glass panel, taking care not to touch the inside, as you will leave fingerprints.
•
Replace the fibre washers over the holes, then replace the screws and tighten them as
•
much as you can using your fingers. Do not use tools.
STORING THE APPLIANCE
Ensure that the Panini Press plug is removed from the power outlet.
•
Ensure the unit has been cleaned and dried thoroughly before storing.
•
Always store in a clean, dry place.
•
SERvICING THE APPLIANCE
There are no user serviceable parts in this appliance. If the unit is not operating correctly, please
check the following:
You have followed the instructions correctly.
•
That the plug is firmly in the wall power outlet.
•
That the wall power outlet is switched on.
•
That the mains power supply is on.
•
If the appliance still does not work after checking the above, contact the Customer Service
department.