How To Operate Your Ceiling Fan; How To Clean Your Ceiling Fan Blades - Fanimation The Odyn FPD8148 Owner's Manual

Restore electrical power to the outlet box by turning
1.
the electricity on at the main fuse box (Figure 1).
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
NOTE: The fan's receiver features an automatic learning
function. There are no frequency switches on the receiver
unit. The receiver will automatically scan the frequency
from the hand held control if any changes are made.
The frequency settings should only be changed in the
case of interference or if multiple ceiling fans with the
same type of control system are installed in the same
structure.
2. To make fan operational, install 23A/12V battery
(included) in hand-held remote transmitter, with fan
power off. Then follow the remote code setting process.
(If not used for long periods of time, remove battery to
prevent damage to transmitter). Store the remote away
from excessive heat or humidly (Figure 2).
3. Remote Control Setting and Speed (RPM)
Setting Process : (Figure 3)
1. After installing the unit and restoring power to
your fan, press and hold the "SET" button 1~5
seconds. You must press the "SET" button
within 60 seconds of restoring power to the fan.
2.The fan will start to run and begin the control
setting process. The fan will run in both
directions for a total of approximately 5 minutes.
3. When the fan stops after approximately 5
minutes the control and speed setting process
is complete.
The fan is now ready for normal use.
4. The remote buttons instruct as below:
Fan speed:
I = minimum speed
III = medium low speed
V = medium high speed
: Turns the fan off.
: Controls fan direction - forward and reverse.
: Controls light-Infinite light levels are available by
holding the light on/off button (Figure 4).

How to Operate Your Ceiling Fan

WARNING
II = low speed
IV = medium speed
VI = high speed
13
MAIN FUSE BOX
Figure 1
Figure 2
Figure 3
Figure 4