Presetting The Displays In The Gauge Mode - Suunto D3 Instruction Manual

4. While the O % level is blinking, press the + and - buttons to increase and
2
decrease the O % level. The corresponding MOD is shown on the display.
2
5.While the PO level is selected, press the + and - to increase and decrease
2
the PO level. Pressing S again returns to O
2
6. After you have calculated the Maximum Operating Depth, exit the MOD
planner by pressing the M button briefly. Keeping the M button down turns
on the light.

3.3.2. PRESETTING THE DISPLAYS IN THE GAUGE MODE

Preset with the - button in the lower left corner of the display (Fig. 3.5.):
• the maximum depth or
• the temperature.
Preset with the + button in the lower right corner of the display (Fig. 3.5.):
• the dive time or
• the current time.
SuuntoD3.p65 29
% selection.
2
29
31.1.2002, 14:17