Table of Contents
Advertisement
NOTE
NOTE
6.3. Diving in the GAUGE mode (DIVE Gauge)
If set to the GAUGE mode, the dive computer can be used as a bottom timer.
In the GAUGE mode, the total dive time is always displayed in minutes in the lower
right corner. In addition, a Dive Timer in the center window displays time in minutes
and seconds. The center window Dive Timer is activated at the start of the dive and
it can be reset during the dive and used as a stopwatch by pressing the SELECT
button.
Mix number, O
% and PO
2
scrolling. If the set PO
the PO
value blinking. The dive computer does not allow you to
2
change to a gas whose set PO
mix is shown but cannot be selected.
If no button is pressed in 15 seconds, the dive computer will go
back to the dive display without changing the gas mix. Upon as-
cent, the computer prompts you to change gas when the PO
level you have set for the next mix allows a gas change. The
prompt is a low priority alarm followed by the "Change gas" beep,
sounded once. The Gas mix (O2%) value blinks.
for the mixes are shown when
2
limit is exceeded , it will be shown with
2
is exceeded. In such a case, the
2
2
87
Advertisement
Table of Contents
