Table of Contents
Advertisement
Symptom
No picture
No sound
Good picture
No sound
Dotted lines or
stripes
Double images or
"ghosts"
No color
88
Possible cause
• The power cord, antenna or
VCR is not connected.
• The projection TV is not
turned on.
• The volume level is too
low.
• The sound is muted.
• The broadcast signal has a
transmission problem.
• There is local interference
from cars, neon signs, hair
dryers, power generators,
etc.
• Broadcast signals are
reflected by nearby
mountains or buildings.
• The antenna direction needs
adjustment.
• Use of a booster is
inappropriate.
• The color level setting is too
low.
• The color system setting is
inappropriate.
• The antenna direction needs
adjustment.
Solutions
• Check the power cord, antenna and the VCR
connections.
• Press I/1 on the remote.
• Press 1 on the projection TV to turn off the
projection TV for about five seconds, then
turn it on again.
• Press 2 + to increase the volume level.
• Press % to cancel the muting.
• Press A/B
until a better sound is heard.
• Do not use a hair dryer or other equipment
near the projection TV.
• Adjust the antenna direction for minimum
interference. Contact a Sony dealer for
advice.
• Use a highly directional antenna.
• Use the fine tuning ("Fine") function.
• Adjust the antenna direction. Contact a Sony
dealer for advice.
• Turn off or disconnect the booster if it is in
use.
• Display the "Picture" menu and select
"Personal" of "Picture Mode", then adjust the
"Color" level.
• Display the "Setup" menu and check the
color system ("Color System") setting
(usually set this to "Auto").
• Adjust the antenna direction. Contact a Sony
dealer for advice.
Page
13
28
29
29
41
–
–
–
77
–
–
71
84
–
Advertisement
Table of Contents
