6
Install the new lamp in place, and then
tighten the screw.
Push the cover back on. Make sure that the
hole on the cover aligns with the hole on the
unit. Reattach the lamp cover by tightening
the screw.
Notes
• If the screw of the lamp cover is slanted, the lamp
may not light up properly. In such a case, take out
the screw and reinsert it straight into the screw
hole, then tighten the screw completely.
• If the lamp cover is not reattached securely, the
self-diagnostic function may be triggered and the
1 indicator flashes three times (see page 92).
7
Reattach the front panel securely.
8
Tightly screw the rear side panel in its
place.
Notes
• Consult your Sony dealer for a Sony XL-2300 (for
KF-WS60) replacement lamp.
• Take great care when replacing the lamp or
plugging in/unplugging the connecting cords.
Rough handling may cause the projection TV to
fall, damaging the TV, the TV stand and/or the
floor.
21