Code 15 Sub-Trim Adjustment - JR 10X User Manual

8.5 Code 15
Sub-Trim Adjustment
The Sub-Trim Adjustment is a feature that allows you to elec-
tronically fine tune the centering of your servos and is individual-
ly adjustable for all ten (10) channels with a range of +/-250% in
2% increments (+/-30° servo travel).
Accessing and Utilizing the Sub-Trim Adjustments
To access the Sub-Trim Adjustments, enter Code 15 in the code
number access selection or use the direct mode method.
The screen will appear as follows:
Channel (servo)
Indicates function
Touch
being programed
other five channels
Touch to Touch
increase decrease
trim value trim value
Offset value ±
This feature enables you to electronically correct for slight
mechanical misalignments that previously had to be corrected
manually.
Caution: Do not use excessive sub-trim adjustments since it is
possible to overdrive your servo's maximum travel if it is off-
center. Remember that this is a trim convenience feature. It is not
intended to take the place of the proper mechanical trim adjust-
ments that are necessary on any R/C model. Offset servos can
produce a differential throw effect.
Press the + or - key to increase the amount of sub-trim. To reset
the sub-trims to the factory default of 0, press the + and - keys
simultaneously or press the CL key.
After adjusting the sub-trims for the first five channels, touch the
PAGE key to access the last five channels.
Upon completion of the sub-trim adjustments, press the ENTER
key to memorize the settings and to exit the program.
Note: On previous generation of JR's 10-channel computer
radios, the sub-trim adjustment values are adjustable from 0 to
125% in 1% increments. Your 10X in adjustable in 2% incre-
ments up to 250%. If you're transferring over sub-trim values
from a previous generation JR 10-channel radio to the 10X, the
sub-trim values of the older 10-channel radio must be doubled in
order to properly match when programmed into the 10X.
18
Touch to
to display
memorize data
and exit program
to
Touch and
simultaneously,
or press to
CL
reset to factory
default setting, 0
10X MANUAL Airplane