Reverse Switch; Sub-Trim Adjustment - JR XP810-3 Manual

4.3 Reverse Switch (Function Mode)
The Reverse Switch is an electronic means of reversing the throw
(direction) of a given channel (servo). All eight channels of the
XP8103 offer reversible servo direction. This will ease set-up
during servo installation in your aircraft.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
To Sub-Trim
Adjustment function
To Dual Rate/
Exponential function
4.4 Sub-Trim Adjustment (Function Mode)
The Sub-Trim Adjustment Function allows you to electronically
fine tune the centering of your servos. Individually adjustable for
all eight channels, with a range of + or - 1 25% (+ or - 30
degrees servo travel).
Caution: Do not use excessive sub-trim adjustments as it is
possible to overrun your servo's maximum travel.
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
To Travel Adjust
function
To Reverse Switch
function
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
UP
DN SELECT
Sub-trim value
(max 125)
±
Press the DN and Select keys
simultaneously to access the
Function Mode List Display
UP DN SELECT
Press to display
channels 1-4
and 5-8
(2 Screens)
www.modelflight.com.au
In Function Mode, use the UP or DN key to select the Reverse
Switch function and access by pressing the UP and DN keys
simultaneously.
CH CH
Channel Selection Use + or - to
(1-8)
(normal/reverse)
In Function Mode, use the UP or DN key to select the Reverse
Switch function and access by pressing the UP and DN keys
simultaneously.
CH CH
Channel Selection Increase or
(press to decrease
manipulate arrow) sub-trim value
(L&R/U&D)
ACRO 38
– World's best source of JR products
Channel being programmed
THRO Throttle
AILE Aileron
ELEV Elevator
RUDD Rudder
GEAR Retract landing gear
FLAP Flap (Aux1)
SPOI Spoiler (Aux2)
AUX3 Extra channel (Aux3)
CLEAR
Reset travel
direction to
change
factory preset
(normal)
Channel being programmed
THRO Throttle
AILE Aileron
ELEV Elevator
RUDD Rudder
GEAR Retract landing gear
FLAP Flap (Aux1)
SPOI Spoiler (Aux2)
AUX3 Extra channel (Aux3)
CLEAR
Press to reset
Sub-trim value to
factory preset (0)