Pppoetunnel - D-Link NetDefend DFL-210 Cli Reference Manual

3.22.7. PPPoETunnel

ProxyARPAllInterfaces
ProxyARPInterfaces
Comments
3.22.7. PPPoETunnel
Description
A PPPoE interface is a PPP (point-to-point protocol) tunnel over an existing physical Ethernet inter-
face. Its IP address is dynamically assigned.
Properties
Name
EthernetInterface
IP
Network
DNS1
DNS2
Username
Password
ServiceName
PPPAuthNoAuth
PPPAuthPAP
PPPAuthCHAP
PPPAuthMSCHAP
PPPAuthMSCHAPv2
DialOnDemand
ActivitySensing
Always select all interfaces, including new ones, for publishing
routes via Proxy ARP. (Default: No)
Specifies the interfaces on which the security gateway should
publish routes via Proxy ARP. (Optional)
Text describing the current object. (Optional)
Specifies a symbolic name for the interface. (Identifier)
The physical Ethernet interface that connects to the PPPoE
server network.
The host name to store the assigned IP address in. (Optional)
The network from which traffic should be routed into the tun-
nel.
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
Specifies the username to use for this PPPoE tunnel.
The password to use for this PPPoE tunnel.
Specifies the PPPoE server service name used to distinguish
between two or more PPPoE servers attached to the same net-
work. (Optional)
Allow no authentication for this tunnel. (Default: No)
Use PAP authentication protocol for this tunnel. User name
and password are sent in plaintext. (Default: Yes)
Use CHAP authentication protocol for this tunnel. (Default:
Yes)
Use MS-CHAP authentication protocol for this tunnel.
(Default: Yes)
Use MS-CHAP v2 authentication protocol for this tunnel.
(Default: Yes)
Enable Dial-on-demand which means that the PPPoE tunnel
will not be setup until traffic is sent on the interface. (Default:
No)
Specifies if the dial-on-demand should trigger on inbound or
outbound traffic or both. (Default: BiDirectional)
94
Chapter 3. Configuration Reference